SC430 - 2nd Gen (2001-2010)

Nav screen doesn't tilt

Thread Tools
 
Search this Thread
 
Old 08-30-23, 05:23 PM
  #1  
Macdog6249
Rookie
Thread Starter
 
Macdog6249's Avatar
 
Join Date: Jun 2023
Location: Ontario
Posts: 28
Received 4 Likes on 4 Posts
Default Nav screen doesn't tilt

Just noticed that the Nav Screen doesn't tilt on my 2002 SC430.

Would appreciate any clues on how to correct this issue?
I have had the car for 3 months and love it.

Thank you
Old 08-31-23, 07:51 AM
  #2  
2006SC430
Driver
 
2006SC430's Avatar
 
Join Date: Jul 2020
Location: VA
Posts: 71
Received 22 Likes on 12 Posts
Default

Assuming the button above the climate control doesn't work and it isn't a fuse that is preventing the door from opening, it could be the gear/track or the small motor that operates it is bad (replaceable). In a very quiet place without the engine running, I would try advancing the key to the position just short of engaging the starter, pressing the button above the climate control, and listening for the gear motor.
Old 08-31-23, 09:17 AM
  #3  
Macdog6249
Rookie
Thread Starter
 
Macdog6249's Avatar
 
Join Date: Jun 2023
Location: Ontario
Posts: 28
Received 4 Likes on 4 Posts
Default

Thanks for responding, the door does open to reveal the nav screen, however, when you use the tilt button nothing happens
Old 08-31-23, 10:05 AM
  #4  
NEWONE1
Pit Crew
 
NEWONE1's Avatar
 
Join Date: Mar 2012
Location: CA
Posts: 219
Received 31 Likes on 17 Posts
Default

Are you pressing the tilt button quickly and not holding it down? If so, it’s probably the motor is shot….I just replaced the nav screen unit from Benzeen auto salvage for $300 and it’s working great again…I was going to replace the motor but saw too many guys saying it was a PITA so I passed…

Last edited by NEWONE1; 08-31-23 at 11:02 AM.
Old 08-31-23, 10:45 AM
  #5  
doobs
Intermediate
 
doobs's Avatar
 
Join Date: Jul 2021
Location: VA
Posts: 498
Received 127 Likes on 97 Posts
Default

Originally Posted by NEWONE1
Are you pressing the tilt button quickly and not holding it down? If so, it’s probably the motor is shot….I just replaced mine from Benzeen auto salvage for $300 and it’s working great again…I was going to replace the motor but saw too many guys saying it was a PITA so I passed…
The motor is a challenge to get to.

If you decide to replace the motor, make absolutely certain you get the right one. The two motors in the nav unit are the same, but have different shaft features.

It's easy enough to take the nav unit out and apply voltage to the motors to see if they work without removing the motors. That would indicate a connector or electronics issue.

Good luck
Old 08-31-23, 12:42 PM
  #6  
Macdog6249
Rookie
Thread Starter
 
Macdog6249's Avatar
 
Join Date: Jun 2023
Location: Ontario
Posts: 28
Received 4 Likes on 4 Posts
Default

Ok, good to know,
Thank you.
I'll pull it out when I put the car away for the winter .

Old 08-31-23, 03:27 PM
  #7  
2006SC430
Driver
 
2006SC430's Avatar
 
Join Date: Jul 2020
Location: VA
Posts: 71
Received 22 Likes on 12 Posts
Default

Originally Posted by Macdog6249
Thanks for responding, the door does open to reveal the nav screen, however, when you use the tilt button nothing happens

Really sorry about that. I should have read more carefully. I would try similar steps to see if I can hear the tilt motor. Unless it is just frozen in position and can be freed externally, I would pull the nav unit and inspect where the tilt motor meets the teeth on the track. The replacement motors are inexpensive, so I would replace both door and tilt motors while you have the unit out.
Old 09-01-23, 08:48 AM
  #8  
GmanSC
Pole Position
 
GmanSC's Avatar
 
Join Date: Oct 2015
Location: CA
Posts: 2,924
Received 543 Likes on 413 Posts
Default

I would leave it alone. The tilting does not help much to eliminate the glare.
Old 09-02-23, 05:23 AM
  #9  
Macdog6249
Rookie
Thread Starter
 
Macdog6249's Avatar
 
Join Date: Jun 2023
Location: Ontario
Posts: 28
Received 4 Likes on 4 Posts
Default

Thanks for coming back with that, I'll keep that in mind.
Initially I used to rest mycell phone on its side against the nav screen, until I parked, pulled the key out of the ignition and the nav door closed on my phone. That may be the reason it doesn't tilt any more, I did have to manipulate the door open to recover the phone, the issue may be on the teeth of the tilt motor mechanism as you say.


Originally Posted by 2006SC430
Really sorry about that. I should have read more carefully. I would try similar steps to see if I can hear the tilt motor. Unless it is just frozen in position and can be freed externally, I would pull the nav unit and inspect where the tilt motor meets the teeth on the track. The replacement motors are inexpensive, so I would replace both door and tilt motors while you have the unit out.
Old 09-03-23, 08:28 AM
  #10  
2006SC430
Driver
 
2006SC430's Avatar
 
Join Date: Jul 2020
Location: VA
Posts: 71
Received 22 Likes on 12 Posts
Default

Originally Posted by Macdog6249
Thanks for coming back with that, I'll keep that in mind.
Initially I used to rest mycell phone on its side against the nav screen, until I parked, pulled the key out of the ignition and the nav door closed on my phone. That may be the reason it doesn't tilt any more, I did have to manipulate the door open to recover the phone, the issue may be on the teeth of the tilt motor mechanism as you say.
Given what you have described, I think you are on the right track. If you are going to all the trouble of pulling the nav out, you might want to take a look into replacing it with a modern nav or screen head unit that does nav. It was a PITA replacing it with a head unit, but every time I get in the car I am glad I did it.
Old 09-03-23, 10:24 AM
  #11  
GmanSC
Pole Position
 
GmanSC's Avatar
 
Join Date: Oct 2015
Location: CA
Posts: 2,924
Received 543 Likes on 413 Posts
Default

Originally Posted by 2006SC430
Really sorry about that. I should have read more carefully. I would try similar steps to see if I can hear the tilt motor. Unless it is just frozen in position and can be freed externally, I would pull the nav unit and inspect where the tilt motor meets the teeth on the track. The replacement motors are inexpensive, so I would replace both door and tilt motors while you have the unit out.
Another warning: DO NOT rest your phone on the instrument cluster. The steering wheel retraction will crush the display.
Old 09-03-23, 11:47 AM
  #12  
Macdog6249
Rookie
Thread Starter
 
Macdog6249's Avatar
 
Join Date: Jun 2023
Location: Ontario
Posts: 28
Received 4 Likes on 4 Posts
Default

Originally Posted by 2006SC430
Given what you have described, I think you are on the right track. If you are going to all the trouble of pulling the nav out, you might want to take a look into replacing it with a modern nav or screen head unit that does nav. It was a PITA replacing it with a head unit, but every time I get in the car I am glad I did it.
I tend to use Waze for nav, for what I need it is good.
I am on the lookout for a phone mirroring device to project on to the current nav screen.
Old 09-03-23, 11:52 AM
  #13  
Macdog6249
Rookie
Thread Starter
 
Macdog6249's Avatar
 
Join Date: Jun 2023
Location: Ontario
Posts: 28
Received 4 Likes on 4 Posts
Default

Originally Posted by GmanSC
Another warning: DO NOT rest your phone on the instrument cluster. The steering wheel retraction will crush the display.
I had it on the nav screen, well away from the instrument cluster.
Thanks for the warning though.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
NTM
NX - 2nd Gen (2022-current)
3
08-04-22 03:35 PM
NYCRCF
RC F (2015-present)
4
06-20-22 07:17 PM
Magellan
IS - 3rd Gen (2014-present)
1
08-15-18 06:33 AM
wmgraham
SC430 - 2nd Gen (2001-2010)
12
10-18-17 06:07 PM
Earman
NX - 1st Gen (2015-2021)
0
05-25-16 12:22 PM



Quick Reply: Nav screen doesn't tilt



All times are GMT -7. The time now is 12:06 AM.