PA MVP Motorsports Boost Cut Control Device.....$$$
#1
MVP Motorsports Boost Cut Control Device.....$$$
Up for sale is my BCC that I purchased from MVP (Same thing as Greddy BCC)....this is used to eliminate the factory boost cut from your 2jzgte ECU...it allows you to run more boost.....I decided not to use this as I am saving up to buy a map ecu...
This is very simple to install.....simply cut map sensor wire.....pin 62 on 2JZGTE ECU pinout......Green wire goes to ECU side and White goes to sensor side
The red wire is for a 12 volt source....I just tapped into cigarette lighter for this and black is for a ground....
Only takes about 10 -15 min to install
It is tuned at 4.1 volts
These go for $120 new from MVP....
I can let this go for $75 obo shipped.....PM me if interested
This is very simple to install.....simply cut map sensor wire.....pin 62 on 2JZGTE ECU pinout......Green wire goes to ECU side and White goes to sensor side
The red wire is for a 12 volt source....I just tapped into cigarette lighter for this and black is for a ground....
Only takes about 10 -15 min to install
It is tuned at 4.1 volts
These go for $120 new from MVP....
I can let this go for $75 obo shipped.....PM me if interested
Last edited by CatManD3W; 05-19-15 at 10:19 AM.
#5
You can run as much boost as you want as long as you have enough fuel
Last edited by CatManD3W; 05-25-15 at 07:29 PM.
Thread
Thread Starter
Forum
Replies
Last Post