Manual steering column from supra
#1
Driver
Thread Starter
Manual steering column from supra
Anyone have a clue if a mk4 or mk3 (or any car) manual steering column will fit an sc. Id like to have the more reliable manual column and it weighs less.my telescope doesnt work.
#4
Driver
Thread Starter
Wow, thanks for that i thought the quick fix was for the up and down. If by some way i come across a mk4 column ill try it out. Manual column from a soarer might work
Last edited by Deathbarel; 12-04-19 at 12:50 PM.
#5
Moderator
iTrader: (5)
What you will need to do this are new snap-off security bolts for your original ignition key tumbler assembly to swap over (you have to use an extractor kit on the installed security bolts on both column tumblers to remove them). You will also need to swap over your USDM turn signal/lighting/wiper stalk main assembly including the USDM clock spring. You will need to de-pin from the USDM harness the wiring and switches that control the auto/motorized tilt and telescope functions. Then you also need to steal a little black plastic bezel from the Soarer switchgear assembly and swap that over to your USDM switchgear assembly.
From there the assembly and reinstallation is covered in the USDM SC300/400 TSRM. Your USDM steering column has to be removed exactly as is stated in the TSRM step by step. There isn't a short cut. It will be easier with the engine out of the car but with the engine in the car the oil filter may need to be temporarily removed for clearance to the steering shaft bolt in the engine bay.
This is the truncated/short explanation for whoever it may help.
Thread
Thread Starter
Forum
Replies
Last Post
ZenkiS14
SC- 1st Gen (1992-2000)
17
07-10-09 01:49 AM