1999 sc400 Power seat wiring harness
#1
Driver School Candidate
Thread Starter
1999 sc400 Power seat wiring harness
Although lucky with the tital surge--I had a short(salt water) in the passenger side power seat harness. Burned everything to the connectors and melted the floor connector to the seat harness. Totally confused about the replacement part #.--82191-33660, or 24210,or 24051, etc
seat is passenger, vented seat, not heated, same features as driver seat(but no memory on passenger side).
I am also considering to skip the harness(all the motors, seat belt, harness connectors survived--except the connector input).--if I can find a wiring diagram.
Yes carpet was pulled/cleaned and all connections, gears, tracks cleaned and treated. all motors tested and work. 30A fused replaced.
Your recommendations please
gcollins
seat is passenger, vented seat, not heated, same features as driver seat(but no memory on passenger side).
I am also considering to skip the harness(all the motors, seat belt, harness connectors survived--except the connector input).--if I can find a wiring diagram.
Yes carpet was pulled/cleaned and all connections, gears, tracks cleaned and treated. all motors tested and work. 30A fused replaced.
Your recommendations please
gcollins
#2
Although lucky with the tital surge--I had a short(salt water) in the passenger side power seat harness. Burned everything to the connectors and melted the floor connector to the seat harness. Totally confused about the replacement part #.--82191-33660, or 24210,or 24051, etc
seat is passenger, vented seat, not heated, same features as driver seat(but no memory on passenger side).
I am also considering to skip the harness(all the motors, seat belt, harness connectors survived--except the connector input).--if I can find a wiring diagram.
Yes carpet was pulled/cleaned and all connections, gears, tracks cleaned and treated. all motors tested and work. 30A fused replaced.
Your recommendations please
gcollins
seat is passenger, vented seat, not heated, same features as driver seat(but no memory on passenger side).
I am also considering to skip the harness(all the motors, seat belt, harness connectors survived--except the connector input).--if I can find a wiring diagram.
Yes carpet was pulled/cleaned and all connections, gears, tracks cleaned and treated. all motors tested and work. 30A fused replaced.
Your recommendations please
gcollins
Thread
Thread Starter
Forum
Replies
Last Post
BigBernice
LS - 1st and 2nd Gen (1990-2000)
6
03-13-18 11:36 PM
r0shiro
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
3
01-10-17 02:20 PM
r0shiro
3Gen IS250 / IS350 Classifieds (14-)
0
11-06-16 01:30 PM