Prefitting my shine front bumper today and I have a little bit of a problem with the high beams not fitting perfectly has anyone else had this problem ? They fit decently but not 100%

The holes aren't cut big enough for the high beams and they won't sit flush even when bumper is fully mounted on. That was my experience.

Thanks for the heads up I would've been messing with it forever. Did you use all the hard ware from the OEM bumper?

Why are you not having your body shop take care of all of that?

I'm not a body guy so I didn't even try messing around with any fitment on my own. I had my body shop do all of the trimming and adjustments before they painted the body kit and the entire car.

I didn't have the Shine front but I do have the Shine sides and rear, along with a +97 OEM front end and Fujin Lip.

I figured I could do it myself. College football player on a budget. Its not turning out bad its honestly not too bad. Im going to finish drilling the holes today.

Mine fit perfect. You can adjust the high beams to bring them out a little. That's what I did.

Shane

So they fit in the holes like oem? Did you use a heat gun? I'm trying to get mine that way but it doesn't look possible.Ill retry when I Have it painted.

Is this the poly version or fiberglass?

polyurethane

Yes I used all the hardware from the Oem bumper. Measure the holes of the poly bumper and the Oem one, you will see the difference. Better yet with the poly bumper off put the high beams right up to the holes, they will not fit

Mine fit fine after I adjusted them. Snug as can be.





Shane

I remember having to adjust the highbeams for them to sit flush w/ the holes