Hi,
Apologies if it has been asked numerous times, but i've read older posts and just need to clarify

I'm going to buy an aftermarket camera , CCD,NTSC/PAL with reverse picture

(am i correct? any suggestions from recent sources)?


Buy a male/female 6 pin connector, cut off original connector and arrange the wires as i mention below

Do i have it correct?


Pin 1...Black/Red, Connect to inner of Camera socket (live), connect also to Purple Green (EMV Power/Sensor)
Pin 2...White, Video Live (Inner)
Pin 3...White/Black,Connect to Outer of camera socket (Earth)
Pin4...Purple/Green, EMV power, connect to 12v+, (reverse wire??)
Pin5...Green/Orange, Not Used
Pin 6...Brown/Black, Video ground (Outer)

Thanks in advance!