98Sc3001jz

Here's some pics of my 1jz swap. im still in the progress of putting the motor and tranny in but these are just a couple pics.

blk&blu*j

iTrader: (1)

That looks like a Supra 1JZ swap with an upgraded down pipe. On a side note this is an earlier 1JZ

joe diego

iTrader: (3)

Looks really clean!

98Sc3001jz

i was told that the engine come out of a soarer. i add the down-pipe figured it would be easier while it was out and thank god i did it this way bc it would be completely impossible to do with the engine in the car

98Sc3001jz

how can you tell its from a supra or that its an earlier 1j?

StiCk3

iTrader: (5)

it's an earlier 1JZ in that the PCV intake pipe is different on the early 1Js and weren't effective at drawing crankcase ventilation. There was a TSB on it and it involved an upgraded PCV valve (same as a MKIV supra one). It's a Soarer if the ECU that came with it has 4 rows of pins on all 4 connectors. Can't remember anything else about it other than that.

GTX580

iTrader: (3)

Goodluck with swap. My 1JZ is being delivered tomorrow. Found this pic from the supra forum regarding old vs new 1jz

98Sc3001jz

Thanks. So far the only reall issue im having is with with the alternator bc when i pulled the 2jz-ge out the clip on the alt stayed in the car and the 1jz's alt clip just runs into the wiring harness so im trying to figure out what to do. And im going from auto to manual and the clutch pedal bracket is a ***** and a half to get in

98Sc3001jz

Top pic is the 1jz alternator and the wires just run back into the wiring harness.
Second pic is the alt clip that came off the 2jz and it goes into the harness that stays in the car.

98Sc3001jz

OK so here's where i'm at right now with the swap.i have the engine and tranny in. i also have the FMIC in but i have a little tweaking to do to it. One side sits down about an inch or so lower than the other but its nothing major. i also have the power steering cooling lines removed BC its in the way of the IC pipes, but the kit came with a PS cooler. Im also having issues with the shifter bc the stock swan shifter extension hits the tranny tub so im just gonna cut out the area that its hitting. Im trying to upload pics but its not letting me so ill try to resize them.

98Sc3001jz

Heres the engine shot

TweakTech

iTrader: (2)

When you have your harness converted, the alt wiring issue will be resolved.

1JZPWRD

iTrader: (59)

This swap looks like a familiar face. Looks like you did this a day or so. Looking good, and I learned something about the new and old 1JZ.

DoomLight

iTrader: (3)

thats mosdef a soarer swap. good looks!

sclee00

more please lol