Can't find Tilt Telescopic ECU.
#1
Driver
Thread Starter
Can't find Tilt Telescopic ECU.
This started as a quest to fix my seat memory. I found this old thread https://www.clublexus.com/forums/sc-...5spd-swap.html which gave me a lead. It was a long shot, but I was going to ground out that gray wire and see if it fixes it, unfortunately I never thought I wouldn't even be able to find the ECU ! Most people that have done a manual tranny swap say the Tilt ECU is right where the clutch pedal needs to go. Well my car was swapped, but from a 5spd to a 6spd, so it always had a clutch pedal. I assume the ecu was in a different spot on the factory manual cars. I circled a bolt hole in this pic, Can someone tell me if that is where the Tilt ECU is normally mounted? And anyone have an idea where it might be?
#3
Lexus Test Driver
iTrader: (2)
It's to the left of the cruise control ECU, at least it should be. I'd take a pic of where it is in my car, but mine is zip tied from a 5spd swap.
You sure it wasn't just taken out?
If you have 2 long loose plugs, you'll know you have a missing unit. I can send you one, just pay for shipping and it's yours.
You sure it wasn't just taken out?
If you have 2 long loose plugs, you'll know you have a missing unit. I can send you one, just pay for shipping and it's yours.
#4
Driver
Thread Starter
wouldn't you see it in this pic? Or is it further to the left? I doubt it was taken out, my tilt and telescopic works, manual and auto. And EVERYTHING power on the seats works except the memory.
#6
Driver
Thread Starter
Just a follow up, I did in fact find the Tilt ECU, it's nowhere near the pedals. On a factory 5 speed car it's on the right side. You have to remove the glove box, and the structural lower dash bar, and the A/C duct and then it's in plain sight, mine was green though, not white. I found the gray wire at B6, made a little jumper and grounded it under a nearby screw and voila the seat memory works !! This is great news, even though I'm the only driver, LOL.
#7
Driver School Candidate
Join Date: Aug 2014
Location: ca
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Just a follow up, I did in fact find the Tilt ECU, it's nowhere near the pedals. On a factory 5 speed car it's on the right side. You have to remove the glove box, and the structural lower dash bar, and the A/C duct and then it's in plain sight, mine was green though, not white. I found the gray wire at B6, made a little jumper and grounded it under a nearby screw and voila the seat memory works !! This is great news, even though I'm the only driver, LOL.
And for the automatic where is the tilt ecu
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
williamb82
LS - 1st and 2nd Gen (1990-2000)
26
08-15-17 07:50 PM