My 1st Lex...'99 SC400 (56k oh noes...)
05-26-09, 07:53 PM
#32
Banned
iTrader: (3)
Join Date: Sep 2008
Location: NA
Posts: 1,262
Likes: 0
Received 0 Likes
on
0 Posts
That is to much, i would pay 8k for a mint condition 99-00 with 50-90k miles. But the vvt-i 1uz is a rare car engine and i believe you have the 3 spoke wheel which is also rate so as long as your happy thats call that matters.
nice buy.
05-27-09, 11:58 AM
#38
Disagree.
The 99 sc400 Durrby purchased is appropriately valued, even in this economy.
It's a clean and rare configuration, and would easily last another 100,000 miles on the odometer.
Agreed: Beauty is in the eyes of the beholder.
The 99 sc400 Durrby purchased is appropriately valued, even in this economy.
It's a clean and rare configuration, and would easily last another 100,000 miles on the odometer.
Agreed: Beauty is in the eyes of the beholder.
05-27-09, 01:49 PM
#39
Driver School Candidate
Join Date: Feb 2007
Location: Chicago
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
05-27-09, 03:06 PM
#40
Lexus Test Driver
I like it. I was rolling the same sizes (assuming the rears are 9.5" with a high offset) for awhile and without adjusting the camber and dropped on Espiler springs, there was absolutely no rubbing. If you use any spacers or do a camber kit you will definitely need to roll/trim your fenders or possibly even pull them though.
05-27-09, 08:13 PM
#42
I like it. I was rolling the same sizes (assuming the rears are 9.5" with a high offset) for awhile and without adjusting the camber and dropped on Espiler springs, there was absolutely no rubbing. If you use any spacers or do a camber kit you will definitely need to roll/trim your fenders or possibly even pull them though.
maybe down the road Milt. I'm not really diggin them but what has to be done to swap them? change the harness right?
04-26-16, 06:06 PM
#44
Pole Position
Love what you did with the car!
04-26-16, 11:38 PM
#45
I'm very much still around but not as active as far as posting new threads/updates.
Needless to say it didn't end with just the listed proposed mods.
Not sure how this thread got bumped but I'll briefly list some of the mods that have been done since the last reply in this thread in no particular order.
-Car was resprayed back in late '13 the same factory Angora Beige Metallic
-Shaved antenna/emblems
-IMF headers
-2.25" header back straight pipe exhaust with Magnaflow X-Pipe
-5Zigen Fireball Mega Exhaust
-SRT Intake with race ecu
-Different 20's - Rohana RC7's 20x10 / 20X11
-Fujin VIP front lip
-C6 Z06 Corvette calipers/ISF rotors up front and Supra TT calipers/rotors in the rear
-Clazzio diamond stitched seat covers
-Toyota rain visors
-JDM bubble winker side markers
-Stance GR+ coilovers
-Ikeya Formula front upper control arms
-Megan Racing rear lower control arms/toe arms/traction rods
-Full stereo system
-Popformance climate unit
I also picked up a 2008 ISF Neiman Marcus Edition #6 of 50 back on halloween of last year.
Modding has basically come to a halt on the SC and I'm in the process of modding the ISF slowly but surely.
How's that for a 7 year reply?
Signed up a few months back while looking for an SC. Picked this up 2 weeks ago. She's all stock outside of a new set of staggered 20's and new tint. Let me know what ya think. I don't plan on going too crazy with this. Maybe just some h.i.d.'s, cat/axle-back exhaust, drop.
What should I run as far as spacers. I'm not sure what the offsets are but I think if I used 5mm ones in the rear and 10/15mm ones in the front it'd look a little better.
What should I run as far as spacers. I'm not sure what the offsets are but I think if I used 5mm ones in the rear and 10/15mm ones in the front it'd look a little better.
Not sure how this thread got bumped but I'll briefly list some of the mods that have been done since the last reply in this thread in no particular order.
-Car was resprayed back in late '13 the same factory Angora Beige Metallic
-Shaved antenna/emblems
-IMF headers
-2.25" header back straight pipe exhaust with Magnaflow X-Pipe
-5Zigen Fireball Mega Exhaust
-SRT Intake with race ecu
-Different 20's - Rohana RC7's 20x10 / 20X11
-Fujin VIP front lip
-C6 Z06 Corvette calipers/ISF rotors up front and Supra TT calipers/rotors in the rear
-Clazzio diamond stitched seat covers
-Toyota rain visors
-JDM bubble winker side markers
-Stance GR+ coilovers
-Ikeya Formula front upper control arms
-Megan Racing rear lower control arms/toe arms/traction rods
-Full stereo system
-Popformance climate unit
I also picked up a 2008 ISF Neiman Marcus Edition #6 of 50 back on halloween of last year.
Modding has basically come to a halt on the SC and I'm in the process of modding the ISF slowly but surely.
How's that for a 7 year reply?
The following users liked this post:
tiguy99 (12-26-18)