DeezNuts

iTrader: (3)

Hey guy's I've gone thru a bunch of pages and haven't seen anyone running a +35mm offset.

The wheels I'm looking at are as follows:
18X8.5 about 2" Lip. 26.0 lbs ea
18X9.5 about 3" Lip. 25.5 lbs ea
Bolt Pattern: 5X4.5 or 5X114.3 (4.5")
Offset: +35mm

I plan on running 245/40/18 and 265/35/18

Will this require modification of the wheel wells?

EDIT: Forgot to ask- would I run into issues if I wanted to run the Supra BBK later on?

SChema

iTrader: (2)

^, You'll be okay, +35 is about the norm for factory fenders on those wheel widths.
You can go up to a 275 in the rear if you wish.

As far as clearing TT Brakes, it's hard to say. Offsets do not tell if your wheels will clear the calipers or not, spoke design does.

chingpo05

iTrader: (2)

anyone on this?

SChema

iTrader: (2)

^, Definitely going to need to roll and pull the fenders if you want a decent amount of tire touching the ground. By decent amount, I mean at least 265's in the front and 285's in the rear.

ecstaticSC

iTrader: (3)

Not my car- posting for reference

Advan T7
19x9+18

19x10 +15

status

you guys think 17's would be to small for an sc? theres some used 5zigin FN01RC's i could get here ther 17-10 rear and 17-8.5 front. let me know if u think 17s will look to small

Triple C

iTrader: (2)

Dont get anything less then an 18 inch. you will regret it. And make sure you Stay with a Smaller Number then +35, +25 is great, +15 Start Fender pulling

InhumaneSC

iTrader: (1)

Hey guys, trying to figure out if I would need fender modifications on this set up.

MB Battles
18x9.5 +15
225/40 in the front
245/40 in the rear

vegas_sc4

iTrader: (1)

I ran 17 on mine. In this pic there 17x10 +12 In rear and 17x9 +25 front



Later on I ran 17x10 -0 rear and 17x10 +12 front

2slowsc300

iTrader: (1)

I have 17s doesn't look bad long as your lowered but 18s are comin very soon

NITROxSC4

iTrader: (1)

alright, i've read most of the thread, i know Sheema's setup is similar on pg. 218, but i just need this answered. I have a 95' sc, i'm looking at doing xxr 526. just worried about the rear 18x10.5 +20. i know i would have to roll the fenders, but could i do a good tire stretch and not have to do a pull or adjust camber?

2slowsc300

iTrader: (1)

Depends on how low your car is an those wheels are backordered justa heads up

Triple C

iTrader: (2)

I have an 18 x 10.5 +15, If it was a +25 it would better. Your going to need to pull the fendors a little or have some camber or atleast a 255 35 or 245 40 to Stretch and Still have some rubber to Make contact with the road and not hit the fender lips to bad. ohh dont forget about the Secondary BULG in the rear fendor wells you will for sure notice them if fitment is as tight as +20 10.5 sounds.

OKSTANCE

UGGGH! I was guna throw the 17x10.5s from my s13 on my sc but now that i see how they fit with stock suspension ill probably not do it cus it looks like POOOOOP! even with waaaaay smaller tires its still guna be mexiflush at stock height

2slowsc300

iTrader: (1)

Agreed haha