craaaazzy

iTrader: (4)

please give me ur input on the following combo. my biggest issue would be the tire sizes.

19x8.5 in the Front Offset35
19x9.5 in the rear Offset 40
235 35 ZR19 Front
265 30 ZR19 Rear

mike36

iTrader: (1)

should fit fine

nysupraman

anyone...?

Kaydee

even with stretch i think you would need to roll the rears for a problem free driving...or you can always let it ride high and go slowly over bumps

Mattmannz

You can't have low, flush and stock fenders, it just isn't possible.

Those wheel specs will be close to flush which will cause you problems even with stretched tires.

Just get the fenders done as you will end up wanting to go lower and wider soon.

Matt.

matrixgts

iTrader: (1)

their is no way i can check all of these to see if someone have this set up if you do guide me to the pic.but here goes rim size 20x8.5 all around offset 38 tires 255/35/20 how will this look and i allready have the rims but not the tires.thanks for your help fellas

Kaydee

^ lowered to one finger gap, I'd say you will be sunken by a thumb. I have the same offset in the back, but wider rims, 10'. You will most likely have to modify/remove the front fender liner. Fronts will be sunken by around 2 cm

Miami-SC

iTrader: (1)

whats up guys! trying to figure out what tire size to get. i am going to lower the car pretty low and i want flushness if possible. the wheels are 19x8.5F +24 and 19x10R +40. i like the stretch look but not extreme.spacer size if possible too. thanks

ColtSwitch

anyone running privat netz? Yes, I did a search.

craaaazzy

iTrader: (4)

decided on something else:

ccw 505a's.
19x8.5 front w/ 235/35/19
19x11 in the rear w/ 295/30/19

roll required to fit the rears.

silhoulex

19x10 + 26 work vskfs, slight fender roll needed

mr2tosc4

iTrader: (1)

19x10 +26 all around? that looks very good!

mr2tosc4

iTrader: (1)

18 x 8 +26 is kinda like 18 x 9 +34, fronts will be sunk by a very little bit, can get away with no roll, my type of fitment.

18 x 9 +20 Rears definitely need rolling even with a slight drop.

VVhite

Looking for alot of advise. My goal is to make no fender mods with no rubbing but the offsets for the wheels I want are limited. Also suggestions for tires? Will this work and look OK?

18x9 front offset +30
18x10 rear offset +40

Kaydee

check my sig, it should look somewhat like that...although your fronts stick out just a tiny bit

you will need a slight roll in the back if you do decide to lower it