Just got my Blitz Nur Spec!
03-05-07, 05:05 PM
#46
Driver
Join Date: Nov 2006
Location: MI
Posts: 120
Likes: 0
Received 0 Likes
on
0 Posts
Video has been uploaded. It's cold in Iowa.
http://www.youtube.com/watch?v=4YECmMqBoZE
First couple high revs are to 6krpms, then the final revs are held at 3krpms. This is with out the silencer in. It is considerably quieter with the silencer in.
http://www.youtube.com/watch?v=4YECmMqBoZE
First couple high revs are to 6krpms, then the final revs are held at 3krpms. This is with out the silencer in. It is considerably quieter with the silencer in.
(second one down)
I plan on getting the same type of exhaust you have and mold the opposing side so there's just one exhaust outlet on the rear bumper and rear lip.
03-05-07, 09:11 PM
#47
Baoser's car
http://www.youtube.com/watch?v=iLQyl1kpqCQ
Mine
http://www.youtube.com/watch?v=ivZxkF46bL0
I'll get better vids (rolling vids) later in the week when I'm not too busy with work and school
http://www.youtube.com/watch?v=iLQyl1kpqCQ
Mine
http://www.youtube.com/watch?v=ivZxkF46bL0
I'll get better vids (rolling vids) later in the week when I'm not too busy with work and school
Last edited by Aries; 03-05-07 at 09:17 PM.
03-06-07, 06:15 AM
#52
Pole Position
Join Date: Sep 2006
Location: Iowa
Posts: 256
Likes: 0
Received 0 Likes
on
0 Posts
Is your exhaust system the same as described here: http://www.mvpmotorsports.com/Templa...946&SearchYN=N
(second one down)
I plan on getting the same type of exhaust you have and mold the opposing side so there's just one exhaust outlet on the rear bumper and rear lip.
(second one down)
I plan on getting the same type of exhaust you have and mold the opposing side so there's just one exhaust outlet on the rear bumper and rear lip.
08-10-08, 08:27 PM
#58
Lead Lap
Thread Starter
Starting at the Y pipe flange, so after the cat. piping from cat back to axels. need to get them tweaked a little bit cause the angels are a bit off and exhaust points akward...
