Okay, I have a dashboard rattle. Passenger side. It goes away if I put a finger on the plastic part between the glove compartment and the door (about three inch wide plastic part).

It is getting worse though. .Before I could just lean over and touch the plastic part, then the noise would go away for the rest of the ride. Now? Not so much. Noise stays unless someone is putting pressure on the part.

So my question is, where are the clips/screws that hold the dashboard on in that area?

I'm thinking I should be able to remove the outbound plastic piece and see a couple of screws or something, or maybe there are screws in the glove compartment somewhere?

I'll take pictures tomorrow and post. If anyone has suggestions... I'm all ears!

Thanks guys.

2010 RX 350