TR3XX

iTrader: (1)

Today I swapped out the yellow amber blinker bulbs with the Phillips SilverVision bulbs. They are silver in color but blink amber. I'm quite happy with the results. You can see a little bit of amber still on the rear at certain angles but it's much less noticeable than the stock bulb. Sorry if this mod has already been posted.

Phillips SilverVision


Front (before)


Front (after)


Signal On


Rear (before)


Rear (after)

RXSF

looks great

socalJD

I have these bulbs too, but haven't installed yet.
The rear bulbs install looks fairly simple, but not sure I want to deal w/the washer fluid & coolant reservoirs to get at the front bulbs . . .

kitlz

TR3XX, look very nice. I might consider changing the front bulbs so all the lights look the same. The rear, I'm not sure. I might need another picture to see the difference. Thanks for sharing.

Perfect timing, I just finished the interior bulbs. Cargo area LEDs came in today. Good news, they fit, sort of. I'm waiting until dark to see how they look.

Joeb427

iTrader: (1)

I like the mod very much and just bought the same bulbs.
How's the install?

lamar411

Looks pretty good. Any pics from far away?

MEP7557

I like the look. See what you started. I think I will do at least the rear. Cleans up the look.

TR3XX

iTrader: (1)

Thanks, I'm happy with the results.

The front is quite easy, all that's needed is remove the bolt holding the reservoir. It took me less than 15 minutes for both sides.

I'll try and take some pictures tomorrow now that it stopped raining. You can barely see any yellow on the rear when it's out in the sun.

Thank you. Both sides took about 15 minutes.

I'll share some tomorrow once the sun is out. The rain here in SoCal have been pretty crazy (for socal )

haha, it's really not my fault. I blame it on Tiggerr, Joeb427 and kitlz, they started it with the LEDs

TR3XX

iTrader: (1)

Some outdoor pics....

kitlz

Tran, I received the bulbs today and changed out the rear blinker bulbs. It is definitely an improvement - matches the others minus the orange glow when off. But I ran into a problem in the front. The SilverVision doesn't fit Below is a picture of both, OE on the left, SilverVision on the right. Did your OE bulb look like mine? The manual lists the same bulb size for the front and rear

On the plus side, all of the bulbs including the LEDs are easy to get to

RXSF

is the light output/color the same as OEM?

kitlz

The light output might be a little brighter. The color is definitely similar. I'd describe it as more as yellowish orange, same as the others. To test it, I turned on the hazard lights and walked around. I couldn't tell any difference. I will put one of the old bulbs in tomorrow to do a cross check. Now if I can only figure out how to change out the front. It would be pretty awesome to have three 'white' lights.

MEP7557

Where did you guys get your bulbs and how much did you pay? I have been looking around and they seem to be a little pricey and not readily available.

Thnx

Joeb427

iTrader: (1)

I got my Phillips Silver Visions on Ebay.
At $52 shipped for 4 bulbs,pricey and not readily available indeed.

kitlz

I got mine from eBay too. The company is MotiveMods. I bought the last two they listed but you can get it from their site too.

http://www.motivemods.com/Philips-Si.../phi-sv-wy.htm

To lose the amber in the back is worth the price Installation is very easy. Now if I can only figure out the front bulbs