Drivers side window controls
My drivers side window controls for all the other windows(except the drivers window) stop working..They work at each individual window control but not from
the drivers side. Any one had this problem. 2007 RX350..
the drivers side. Any one had this problem. 2007 RX350..
I just experienced that problem on my 2005 RX330. During service, the battery was disconnected, resulting in some of the computerized system codes being lost. The Lexus dealer re-entered the codes and everything is working perfectly.
Here's how to initialize the power windows if you ever disconnect the battery:
1. Turn the ignition to "on".
2. The light in the button for the driver's window will be blinking. If it's not blinking, it doesn't need initializing.
3. Open the driver's window all the way.
4. Pull up on the switch to close the window, and continue holding the switch up for about one second until after the window closes. The light will stop blinking, and then you can release the switch.
5. The power windows should all work normally, and the jam protection feature should be enabled.
1. Turn the ignition to "on".
2. The light in the button for the driver's window will be blinking. If it's not blinking, it doesn't need initializing.
3. Open the driver's window all the way.
4. Pull up on the switch to close the window, and continue holding the switch up for about one second until after the window closes. The light will stop blinking, and then you can release the switch.
5. The power windows should all work normally, and the jam protection feature should be enabled.
Trending Topics
Nope, I think you read it wrong or one of us read it wrong. The lock out stops the controls at each door from working (this stops kids in the back seat from playing with the buttons) I believe he said that the controls on all the other doors work but the driver's controls don't work.
Here's how to initialize the power windows if you ever disconnect the battery:
1. Turn the ignition to "on".
2. The light in the button for the driver's window will be blinking. If it's not blinking, it doesn't need initializing.
3. Open the driver's window all the way.
4. Pull up on the switch to close the window, and continue holding the switch up for about one second until after the window closes. The light will stop blinking, and then you can release the switch.
5. The power windows should all work normally, and the jam protection feature should be enabled.
1. Turn the ignition to "on".
2. The light in the button for the driver's window will be blinking. If it's not blinking, it doesn't need initializing.
3. Open the driver's window all the way.
4. Pull up on the switch to close the window, and continue holding the switch up for about one second until after the window closes. The light will stop blinking, and then you can release the switch.
5. The power windows should all work normally, and the jam protection feature should be enabled.
Thread
Thread Starter
Forum
Replies
Last Post
carlos3366
IS - 2nd Gen (2006-2013)
6
Feb 4, 2015 11:08 AM




