DIY backup camera integrate with gps nav screen
#1
Lexus Test Driver
Thread Starter
DIY backup camera integrate with gps nav screen
I bought Navtool rgb and connected with gps nav screen by following configs.:
1. 12v dc power red wire connected with NAV dvd ecm plug N3 pin # 18 (grey) -ACC
2.Black ground wire connected with NAV ecm plug N3 pin # 17 (White and Black)- GROUND
4. Blue wire connected with plug N3 # 14 pin (red and black) - reverse light switch.
5.White wire connected with the same ground.
6.Navtool RGB out connected with the nav ecm ( rear trunk) N4 plug by the male and female harness comes with navtool.
7. I connected rear view camera Boyo VTL402C power red wire to N3 #18 acc and black ground wire with same ground also and yellow video out to # 2 video port in Navtool. I route the wires from the license plate to the right side of the trunk where my nav dvd ecm located.
I will post video link for you tube.
1. 12v dc power red wire connected with NAV dvd ecm plug N3 pin # 18 (grey) -ACC
2.Black ground wire connected with NAV ecm plug N3 pin # 17 (White and Black)- GROUND
4. Blue wire connected with plug N3 # 14 pin (red and black) - reverse light switch.
5.White wire connected with the same ground.
6.Navtool RGB out connected with the nav ecm ( rear trunk) N4 plug by the male and female harness comes with navtool.
7. I connected rear view camera Boyo VTL402C power red wire to N3 #18 acc and black ground wire with same ground also and yellow video out to # 2 video port in Navtool. I route the wires from the license plate to the right side of the trunk where my nav dvd ecm located.
I will post video link for you tube.
Last edited by gazi001; 06-12-12 at 05:28 PM.
#2
Lexus Test Driver
Thread Starter
#5
Driver School Candidate
Join Date: Dec 2012
Location: CA
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the instructions. Good job. I noticed on one of your pictures that you have another module on top of you dashboard, Looks like a mobile GPS. You use two GPS's.?
#6
Moderator
gazi001:
Great DIY thread.
Can you please create a link in the Sticky DIY thread.
This thread by itself will not be a sticky. Practically all threads remain till they are archived after a long time.
Our intention is to have only a handful of sticky threads, which provide important info or act as launch point.
Salim
Great DIY thread.
Can you please create a link in the Sticky DIY thread.
This thread by itself will not be a sticky. Practically all threads remain till they are archived after a long time.
Our intention is to have only a handful of sticky threads, which provide important info or act as launch point.
Salim
#7
Racer
Just wondering; Where did you get this backup camera/gps unit from and how much was it; and also; do you know how much it would be to get it professionally installed? I would really like to get a backup camera/gps for mine but dont have the knowledge to install it myself. Thanks for any info, Matt
Thread
Thread Starter
Forum
Replies
Last Post
DshngDaryl
SC430 - 2nd Gen (2001-2010)
28
07-07-20 06:37 PM
VIPNiSS
SC430 - 2nd Gen (2001-2010)
21
04-20-11 12:13 PM