Windows not working after battery is replaced
#1
Driver School Candidate
Thread Starter
Join Date: Apr 2003
Location: International
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Windows not working after battery is replaced
My battery died and was replaced with a new one. After that, the passenger window cannot be controlled by the driver's side, and worse still, the rear windows doesn't work at all.
Is there a reset function I could use, or did a fuse blow? Please help! Thanks.
Is there a reset function I could use, or did a fuse blow? Please help! Thanks.
#4
Here this is from the Manual:
If the battery is disconnected or run down
The power windows may not operate automaticaly and the jam protection function will not function correctly after you reconnect, replace or recharge the battery. At this time, the indicator lights of the switches will flash. In any of these cases, you should normalize the power windows
1. Push down the power window switches of each door and lower the windows halfway.
2. Pull the switches until the windows close and hold the switches for a second.
________________________________
The moon roof may not operate automaticlly and the jam protection functon will not function correctly after you reconnect, replace or recharge the battery. In any of these cases, you should normalize the moon roof.
To normalize the moon roof, push and hold the switch on the "TILT UP" side until the moon roof tilts all the way up and then tilts down a little automatically.
If the battery is disconnected or run down
The power windows may not operate automaticaly and the jam protection function will not function correctly after you reconnect, replace or recharge the battery. At this time, the indicator lights of the switches will flash. In any of these cases, you should normalize the power windows
1. Push down the power window switches of each door and lower the windows halfway.
2. Pull the switches until the windows close and hold the switches for a second.
________________________________
The moon roof may not operate automaticlly and the jam protection functon will not function correctly after you reconnect, replace or recharge the battery. In any of these cases, you should normalize the moon roof.
To normalize the moon roof, push and hold the switch on the "TILT UP" side until the moon roof tilts all the way up and then tilts down a little automatically.
The following users liked this post:
bordenj66 (04-11-21)
#7
Re: Great work
Originally posted by lexsg
Thanks rl9905. I tried it, I it worked! Really appreciate your initiative.
Thanks rl9905. I tried it, I it worked! Really appreciate your initiative.
Originally posted by Fern
Great work Rl9905
I too learned something with your tip..
Great work Rl9905
I too learned something with your tip..
Trending Topics
#10
Moderator
Another invaluable tip ,,,
Read the manual.
Salim
Read the manual.
Salim
#11
This just happened to my IS250.
Thank God for this forum.
Does anyone know why this phenomenon occurs?
Because I changed my ES300 battery a few months ago, and this never happened to the ES300's power windows...
Thank God for this forum.
Does anyone know why this phenomenon occurs?
Because I changed my ES300 battery a few months ago, and this never happened to the ES300's power windows...
#14
Moderator
The memorized limit is lost on the removal of +12v. So the system starts out with minimum settings.
Salim