When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Pulled the fenders and have a new stance and new exhaust
Well its been a big pita but I finally got the stance I was looking for. I got the rear fenders shaved and pulled. Got rid of about 90% of the rub. I think a bit of camber will get rid of the last little bit of rubing I have.
I also Got a K&N intake for xmas and I bought myself a xmas gift.. from the headers back a 2.25 duel exhaust with magnaflow xpipe and duel magnaflow 14829 sounds fantastic
The work looks pretty good! How much did you have to shave? What are the sizes and offsets of the wheels/tires?
I had to shave the whole lip off so it was flush with the inside. The wheels a 20x10 donz montanas with a 30offset in rear and 25 front. Tires are 255/35 rear and 235/30 front
Originally Posted by G2low
what did you lower it on?
They are slammed all the way on Tein CST. Someone else asked if the front can go lower and no they cant they are on the lowest in the front and like a thread or 2 from the lowest in the rear.
I also Got a K&N intake for xmas and I bought myself a xmas gift.. from the headers back a 2.25 duel exhaust with magnaflow xpipe and duel magnaflow 14829 sounds fantastic
Looks good, you finally got S&S headers
Did you feel any difference with the X pipe? I have one, but I have yet to install it.
01-22-09, 12:54 PM
Pulled the fenders and have a new stance and new exhaust
How much did you have to shave?
What are the sizes and offsets of the wheels/tires?
