1 uzfe mods
#1
Driver School Candidate
Thread Starter
1 uzfe mods
I'm new to this sc world, so bare with me. Recently purchased a 1993 sc400 for 600 bucks. It has 286000 miles on it. Since purchasing a month ago, ive been ***** deep in these forums looking for ways to open up the true potential of this v8. There aren't really any mods available.
So, I started with getting the car back to original. 130 amp alternator, battery, plugs, wires, distributors and buttons, water pump, tensioners, timing belt, thermostat, fuses, lower front control arms, intake, full exhaust with gutted cats into two single chamber 40 series flowmaster cans, 340 lph fuel pump, back to back tranny flushes, oil changes as well, flex couplings, crank and cam seals, removed and cleaned throttle body, brakes, rotors, power steering pump and iac valve. Seems to do fine, but its not enough.
Any helpful direction pointing would greatly be appreciated.
So, I started with getting the car back to original. 130 amp alternator, battery, plugs, wires, distributors and buttons, water pump, tensioners, timing belt, thermostat, fuses, lower front control arms, intake, full exhaust with gutted cats into two single chamber 40 series flowmaster cans, 340 lph fuel pump, back to back tranny flushes, oil changes as well, flex couplings, crank and cam seals, removed and cleaned throttle body, brakes, rotors, power steering pump and iac valve. Seems to do fine, but its not enough.
Any helpful direction pointing would greatly be appreciated.
#3
Driver School Candidate
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post