1jzgte vvti (JZS171) ECU PINOUT
05-21-19, 04:38 PM
#46
Driver School Candidate
Join Date: May 2019
Location: NSW
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Hey guys I'm putting a 1JZ VVTI into an mx83 cressida that I believe is from a JZS171 from information I got from googling the numbers on the ECU. If anyone could send me any pinouts or diagrams to jcbknoll@gmail.com that would be greatly appreciated!
01-06-22, 03:21 PM
#47
Driver School Candidate
Join Date: Jan 2022
Location: NC
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
02-10-22, 05:22 PM
#48
Driver School Candidate
Join Date: Feb 2022
Location: NC
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
majbm15@gmail.com
Last edited by JMaC633; 02-11-22 at 12:37 PM. Reason: Email
06-27-22, 05:59 AM
#49
1st Gear
Join Date: Jun 2022
Location: Selangor
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
I'm trying to figure out to wire up my fuel pump so that it will switched on a few seconds when I turn the key to ignition, and then shut down...and will switch on again when i crank my engine.
Thanks in advance.
12-13-22, 01:49 AM
#50
1st Gear
Join Date: Dec 2022
Location: Cape Town
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Pin Out
Good Day
Please can you also send me a copy of the JZS171 Pinout
Converting from 1 GFE motor to 1 JZ in Lexus IS 200
info@fsas.co.za
Thanks
Please can you also send me a copy of the JZS171 Pinout
Converting from 1 GFE motor to 1 JZ in Lexus IS 200
info@fsas.co.za
Thanks
02-05-23, 05:27 PM
#51
1st Gear
Join Date: Feb 2023
Location: Castries
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
