Cluster problem
#1
Cluster problem
Ever since I removed my engine and did a swap my cluster lights and needles stop lighting up.
The only thing that works is the fuel and temp readings. it does show the door light open and other small things like signals
when you turn the key to acc I see the backlights flash for a sec, thats about it
any ideas? is there a ecu or something that controls the cluster at all?
The only thing that works is the fuel and temp readings. it does show the door light open and other small things like signals
when you turn the key to acc I see the backlights flash for a sec, thats about it
any ideas? is there a ecu or something that controls the cluster at all?
#2
update, its not just the cluster I find is the problem, whenever I put the key in, the steering wheel goes all the way up.
when its in ACC the seats dont move but if i have the key out the seats moves fine
everything works like normal other then that
when i unplug the center plug on the cluster it seems like that what controls the steering wheel and seat? like a memory is stored in the cluster
when its in ACC the seats dont move but if i have the key out the seats moves fine
everything works like normal other then that
when i unplug the center plug on the cluster it seems like that what controls the steering wheel and seat? like a memory is stored in the cluster
#3
Pole Position
iTrader: (18)
Did you jump the resistor on the back....R109....I believe this is only for the tachometer.....
What harness are you using?
When I did my swap I got every gauge on the cluster to work minus the speedometer and odometer....
I have traced all the wires and they are correct, put in a new speed sensor, ran new wires, etc....
I still am unable to get the speedometer to work...it just stays at 0
What harness are you using?
When I did my swap I got every gauge on the cluster to work minus the speedometer and odometer....
I have traced all the wires and they are correct, put in a new speed sensor, ran new wires, etc....
I still am unable to get the speedometer to work...it just stays at 0
#4
Did you jump the resistor on the back....R109....I believe this is only for the tachometer.....
What harness are you using?
When I did my swap I got every gauge on the cluster to work minus the speedometer and odometer....
I have traced all the wires and they are correct, put in a new speed sensor, ran new wires, etc....
I still am unable to get the speedometer to work...it just stays at 0
What harness are you using?
When I did my swap I got every gauge on the cluster to work minus the speedometer and odometer....
I have traced all the wires and they are correct, put in a new speed sensor, ran new wires, etc....
I still am unable to get the speedometer to work...it just stays at 0
yes its jumped but the cluster was not working before this after i replaced the bulbs and jumped
all i get is when you turn the key, a flash of the cluster and the steering wheel loses the memory and the seats stop moving, really wierd
Last edited by mikef; 08-13-14 at 05:38 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Bradster
LS - 1st and 2nd Gen (1990-2000)
4
06-20-08 10:39 AM