sc300 2jzgte swap
06-17-14, 12:10 AM
#1
Driver School Candidate
Thread Starter
Join Date: Jun 2014
Location: mn
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
sc300 2jzgte swap
hey guy im new here and im looking for some help. i found a sc300 shell crazy cheap and i would love to do a 1jzgte swap on it. and i found a 1jzgte soarer
motor with the antire wire harness and a 5 speed transmission for around 3 grand. ive read the tread with whole wire harness write up but i would like some one on one help. im willing to pay some one to just guide me with this. by reading the tread i know i have to extend the wire harness other then extenting the harness what else is there that i would need to do? and also if it possible to do so under 5 grand i rather not spend more than that there actually a sc300 in my town for 7 grand with the swap so if i cant keep it under 5 i rather just buy that one. any help or advice would be mich apresiated.
motor with the antire wire harness and a 5 speed transmission for around 3 grand. ive read the tread with whole wire harness write up but i would like some one on one help. im willing to pay some one to just guide me with this. by reading the tread i know i have to extend the wire harness other then extenting the harness what else is there that i would need to do? and also if it possible to do so under 5 grand i rather not spend more than that there actually a sc300 in my town for 7 grand with the swap so if i cant keep it under 5 i rather just buy that one. any help or advice would be mich apresiated.
06-18-14, 10:12 PM
#2
Lexus Champion
iTrader: (13)
Join Date: Feb 2008
Location: Sacramento
Posts: 2,187
Likes: 0
Received 0 Likes
on
0 Posts
If its from a soarer most of it will just bolt on. If the shell isnt a manual youll need to install the clutch pedal, master cylinder, and cut the tunnel to fit the 5spd.
Thread
Thread Starter
Forum
Replies
Last Post
