1jz swap does not throw trouble codes
#1
Driver School Candidate
Thread Starter
Join Date: Oct 2011
Location: CA
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
1jz swap does not throw trouble codes
Hello. My brother moved to Japan and gave me his car. He did the swap himself but I don't get any trouble codes when the motor is acting up. The CEL does come on. I bridge TE2 and E1, but it will always repeatedly blink.
It'll misbehave in small ways, randomly, but the car will never throw codes. I even had a bad coolant temp sensor and a mis-wired O2 sensor which didn't show up on the dash. I replaced some leaking caps which helped it run overall, but still no codes.
Does anyone know what pins I should start looking for? Thanks.
It'll misbehave in small ways, randomly, but the car will never throw codes. I even had a bad coolant temp sensor and a mis-wired O2 sensor which didn't show up on the dash. I replaced some leaking caps which helped it run overall, but still no codes.
Does anyone know what pins I should start looking for? Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
VIPNiSS
SC430 - 2nd Gen (2001-2010)
1
10-24-13 06:37 PM