driveshaft length?
#1
Pole Position
Thread Starter
driveshaft length?
i put a soarer r154 in my sc300 with the mk3 front half of the drive shaft and it seems like its in the tranny too much, when i drive i can hear the yoke hit the black dust shiel that goes around the front of the driveshaft. my tranny mount was bad so i replaced it and the noise got worse. so i put in the old mount till i could figur out this problem. my first step is goin to be a custom 1 piece driveshaft. i think mine is a little to long but not sure how much. does anyone know the length the driveshaft for a 93 sc300 with a soarer r154?
#3
1JZ Single SC400
iTrader: (59)
Join Date: Jan 2009
Location: Alabama, Roll Tide!
Posts: 8,518
Likes: 0
Received 15 Likes
on
12 Posts
Remove the metal trim ring around the tranny where the driveshaft goes in. Replace the cente4 bearing with a mkiv one, then make sure you have SC300 rear driveshaft portion. Will be perfect. If the rear rubber piece on the rear end is bad or cracked, replace it also. Good luck!
#4
Pole Position
Thread Starter
Remove the metal trim ring around the tranny where the driveshaft goes in. Replace the cente4 bearing with a mkiv one, then make sure you have SC300 rear driveshaft portion. Will be perfect. If the rear rubber piece on the rear end is bad or cracked, replace it also. Good luck!
Thread
Thread Starter
Forum
Replies
Last Post
1JZPWRD
SC400 / 300 Classifieds
4
01-27-12 05:43 PM