Hello all,

Just finished installing new R12 AC compressor and dryer. Everything back on except the top plate where the suction and discharge lines attach. The old one has 4 torx head bolts. I have soaked with penetrating oil but they won't budge. A 40 torx is too small and a 45 is too big. Tried to use a 6mm allen but it starts to strip the bolt so stopped.

Would appreciate any suggestions. Wen't to Oreilly's and Autozone but neither had the right socket. They suggested a Lexus dealer. I can't believe there is not a way for us DIY'rs to take this off. The new compressor did not come with a new cover.

Thanks for the help,

LMA

 

Remove Compressor again (I know), cut torx off, extract, re-install something you can use.

I had a hell of a time doing mine.

They were allen heads, but an allen wrench didn't have enough torque, and the allen sockets I have are too shallow.

I had to grind away some of the housing to get to that one.