1.5JZ Code 55-rear knock sensor
04-25-11, 08:55 PM
#1
1.5JZ Code 55-rear knock sensor
I just got the damn thing running and it came out better than my first attempt, Thank GOD. Car fires up with no issues except that it idles low and a little rough. The CEL kicked on and I pulled a 55 code, from researching it looks like my rear Knock sensor.
How would I check continuity on this? And what should it measure? I extended the wire harness and used sheilded USB wire on both KS. I dont think the wiring can be a culprit cause its only throwing a 55 code.
Can I use a 2JZGE KS or are they completely different?
How would I check continuity on this? And what should it measure? I extended the wire harness and used sheilded USB wire on both KS. I dont think the wiring can be a culprit cause its only throwing a 55 code.
Can I use a 2JZGE KS or are they completely different?
Last edited by 6SOARER; 04-25-11 at 10:29 PM.
04-26-11, 05:22 AM
#3
It is but by not much. Question about the USB wire, when people say they are using USB wire its computer USB wire?
I really dont think its the gauge wire size cause I extended the front one as well and its not throwing a code for that knock sensor.
I really dont think its the gauge wire size cause I extended the front one as well and its not throwing a code for that knock sensor.
Thread
Thread Starter
Forum
Replies
Last Post
LexBrett
SC430 - 2nd Gen (2001-2010)
2
08-31-15 05:23 PM
