GenIII 6.0/t-56 swap thread
02-20-11, 10:00 PM
#16
Pole Position
Thread Starter
Join Date: Aug 2009
Location: CA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
411 is the ecu that gm used in the camaro, corvette, and firebird. It is the ecu that is drive by cable and is the better of the gm ecu's from what i understand.
02-20-11, 10:15 PM
#18
Pole Position
Thread Starter
Join Date: Aug 2009
Location: CA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
Before i put the motor in, i will be installing texas speeds torquer v2 camshaft and valvetrain upgrade kit. DGR also quoted me $900 for a set of their custom made longtube headers. No thanks. I will make them myself. $180 for a diy longtube kit that comes complete with flanges, mandrel u bends, and 3" collectors. here is a vid of a torquer cam http://www.youtube.com/watch?v=-AxFEV9b0Y8
02-21-11, 07:00 AM
#19
lmfao.......that is so true at first i was quoted $1200. but then i was like ok, i dont need my sub frame modified because i know i can do that myself. For 800 i got both motor mounts, the trans crossmember, and the trans urethane mount. i still need to buy the urethane mounts that go in between the dgr mounts and the subframe.
02-22-11, 01:16 PM
#21
Driver
Join Date: Jan 2011
Location: KS
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
I was also quoted $1200 for just the mounts.
For that much money I'll figure it out myself. Especially when you're thinking about doing a 5.3+A4 swap, thats more than the entire drivetrain would cost me.... by a lot.
For that much money I'll figure it out myself. Especially when you're thinking about doing a 5.3+A4 swap, thats more than the entire drivetrain would cost me.... by a lot.
02-22-11, 11:19 PM
#22
Pole Position
Thread Starter
Join Date: Aug 2009
Location: CA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
02-25-11, 12:46 AM
#23
Pole Position
Thread Starter
Join Date: Aug 2009
Location: CA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
f body balancer and water pump
cluth slave with mcleod -4AN converter.
wilwood 7/8 remote master cylinder
arp flywheel and clutch bolts
fbody oil pan windage tray and pickup tube
cluth slave with mcleod -4AN converter.
wilwood 7/8 remote master cylinder
arp flywheel and clutch bolts
fbody oil pan windage tray and pickup tube
