Disconnect Kickdown-switch for Dyno?
12-27-10, 11:26 AM
#1
Disconnect Kickdown-switch for Dyno?
Hello!
I see on all SC400 Dyno-sheet the start-rpm is over 3500u/min.
My idea: Switch O/D off and shift up in the 3rd gear, after this, cut the connection from the kickdown-switch and i can start the dyno with lower rpmīs as 3500u/min to have a full dyno-sheet. Normaly, i can pull down to full throttle in the 3rd gear on lower rpmīs without switch back in the 2nd gear?
Or is this not a good idea? Maybe too much for the converter or tranny?
greets
Tom
I see on all SC400 Dyno-sheet the start-rpm is over 3500u/min.
My idea: Switch O/D off and shift up in the 3rd gear, after this, cut the connection from the kickdown-switch and i can start the dyno with lower rpmīs as 3500u/min to have a full dyno-sheet. Normaly, i can pull down to full throttle in the 3rd gear on lower rpmīs without switch back in the 2nd gear?
Or is this not a good idea? Maybe too much for the converter or tranny?
greets
Tom
Last edited by Boergy; 12-27-10 at 11:30 AM.
Thread
Thread Starter
Forum
Replies
Last Post
stlgrym3
IS - 2nd Gen (2006-2013)
40
03-11-15 11:54 AM
