Need some help quick: Transmission removal
06-04-10, 09:15 PM
#17
Lead Lap
Thread Starter
iTrader: (1)
Join Date: Jan 2009
Location: Cumming, Georgia
Posts: 599
Likes: 0
Received 0 Likes
on
0 Posts
06-06-10, 09:02 AM
#18
Haven't been on for a couple of days, so sounds like you're making some progress. If you haven't figured it out by now, CCW = Counter-Clock-Wise. Not much play in the bolt holes, so install everyone one, loosely at 1st. Torque them after all installed. While you're under the trans can you check the position of wires on the O/D speed sensor (located at forward left side). Who ever messed with my trans before broke the plastic on the wire harness, so all I have are 2 loose wires (pink and green) with no plastic connector. When connecting to the trans, which color wire is toward front of trans, pink or green? Good luck on the torque convertor bolts!
04-13-18, 04:45 PM
#19
Driver School Candidate
Join Date: Apr 2018
Location: Georgia
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Ok so I have the trans all lined up, semi bolted on, before hand, I lined up the torque converter bolt holes with the flex plates, now they aren't lined up. Does anyone have any suggestions on lining these up? and is there anyway to spin the torque converter from the outside of the trans?
How did you line the torque converter up with the flywheel??
Thread
Thread Starter
Forum
Replies
Last Post
marvin5881
LS - 1st and 2nd Gen (1990-2000)
10
03-23-19 01:06 AM
