Looking for Someone(In Regards to a Manifold)
#1
Lexus Test Driver
Thread Starter
iTrader: (1)
Join Date: Nov 2004
Location: MN
Posts: 924
Likes: 0
Received 0 Likes
on
0 Posts
Looking for Someone(In Regards to a Manifold)
A few years back when I had my other SC300, there use to be a guy on here out of.... Pennsylvania/East Coast area who use to make Log manifolds for the 2JZGE. Anyone know who he is-I know he was a member? I bought one back in the day, and I want to get one again if he's still around. I've searched with no luck on finding who he is. He did a few manifolds, KA24DE's, DSMs, etc... It pretty much was a basic log manifold to accept a T4 w/ a 38mm Tial/Deltagate flange on the bottom and he wanted ~ $300 for them.
***Before someone talks a bunch of crap, the only reason I'm considering this is because the Turbonetics manifold is a rip-off and the ebay ones "could" crack/and I dont' want to cut/re-weld the angle of the flange. (And I'm not looking for lots of power, just something really basic (sub 8 psi) to add a little fun for my daily driver 97.
Thanks to anyone who can help.
***Before someone talks a bunch of crap, the only reason I'm considering this is because the Turbonetics manifold is a rip-off and the ebay ones "could" crack/and I dont' want to cut/re-weld the angle of the flange. (And I'm not looking for lots of power, just something really basic (sub 8 psi) to add a little fun for my daily driver 97.
Thanks to anyone who can help.
#3
Lexus Test Driver
Thread Starter
iTrader: (1)
Join Date: Nov 2004
Location: MN
Posts: 924
Likes: 0
Received 0 Likes
on
0 Posts
Try this http://www.boostwerx.com/
Thread
Thread Starter
Forum
Replies
Last Post
HiPSI
Performance & Maintenance
61
04-16-15 12:49 AM