vntperform

iTrader: (15)

Folks had a question...

A 97 sc3OO with a usdm 2jz-gte w/v160 swap and his speedometer follows the revs from the tach when the car is driven fast/hard. Basically if you rev the car up... the Tachometer goes up but the speedometer follows even though your sitting still....

Any suggestions, or comments on what the issue could be?

Thanks!

TheMole

iTrader: (13)

Was it previously an automatic? Could be wiring issues.

Maybe this thread is of help: https://www.clublexus.com/forums/sho...d.php?t=284613

vntperform

iTrader: (15)

Yes it was an auto prior to the swap... does ^that still apply?

sc250tt

all you have to do is find your tach wire .i will try to get the pinout for you

Edit: on ik1 bodyplug the wires are on pin 6 and pin 7 ,cheack and see if those are pinned on the gte harness

vntperform

iTrader: (15)

Where is ik1 and what pins should they be?

Forgive me as i'm a newb to the whole swap business, I bought the car with the swap already done and just want to tie up some loose ends.

sc250tt

this thread has pics of the plug ik1 is right next to ik2
https://www.clublexus.com/forums/sho...d.php?t=236548

vntperform

iTrader: (15)

This will remedy my speedometer issue?

vntperform

iTrader: (15)

Anyone?

My tach is working fine, but my speedo goes buzzerk regardless of what you do...and it was fine before the 2jz-gte and v160 swap. Any ideas, anyone?

vntperform

iTrader: (15)

sc250tt,

you referring to the orange plug?

sc250tt

i sent you a pdf ,hopefully it can help

vntperform

iTrader: (15)

Sc250,

I received the pdf file you sent me yesterday, but it DOES NOT tell you where the IK type plugs are or what the details of the plugs are it just gives you the schemetics of wiring. Do you have any other electrical diagrams for the sc? I'm stumbled and frusterated.

All I need is the full electrical diagram that shows the actual plug and what each plug represents.

Supra Dr

iTrader: (14)

Val, the IK plugs are above the right kick panel. The 1 link
shows the plug in hand.

Sounds like the tach & speedo are spliced to gether by accident.

vntperform

iTrader: (15)

Supra Dr;

Thank you for responding, finally someone that can help me!

I traced the 2 wires from IK1 one is a solid red on pin 6 and one is a solid blue with red tracer on pin 7 and I traced them all the way up to the gte harness and they are exactly as they should be, connected to the same two wires from the gte harness. Now i'm wondering if there is an issue with the wiring behind the cluster. Would that be where the tach and speedo wires come together?

Sounds like the tach & speedo are spliced to gether by accident.

Well the speedo only goes crazy while driving, if your sitting still and you rev the engine up; the speedo stays at zero. But while driving the speedo needle is bouncing all over the place; at times it reads accurate, but if you hammer it then it goes all outta wack.

Also thanks to sc250tt for the schematic.

sc250tt

so if it is in the right pins maby your speed sensor is bad .i saw a kid on sf having the same problem with the speed jumping around when driving hard .did you fix the tach?

vntperform

iTrader: (15)

my tach is fine, has always worked properly.

Got a link to his problem?