95 SC400 ect problem
#1
Driver School Candidate
Thread Starter
Join Date: Apr 2006
Location: nc
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
95 SC400 ect problem
He guy's,
Having a problem with the electronic control transmission. Here's the problem, when I move the switch to power the control unit is not engaging and changing the shifting points to a higher rpm. It runs in normal mode at all times. Is there a sensor in the transmission that would cause this. Also, I did a diagnostic check by jumping the e1 and te1 terminals and the OD light and check engine light blinks rapidly which indicates not codes in the ecm. But I only thought the check engine light was suppose to blink, however; if I press the Overdrive button to over drive off the OD light goes out. Any suggestions.
Thanks for any suggestions, I have not seen any post after advance searching for nearly an hour.
Having a problem with the electronic control transmission. Here's the problem, when I move the switch to power the control unit is not engaging and changing the shifting points to a higher rpm. It runs in normal mode at all times. Is there a sensor in the transmission that would cause this. Also, I did a diagnostic check by jumping the e1 and te1 terminals and the OD light and check engine light blinks rapidly which indicates not codes in the ecm. But I only thought the check engine light was suppose to blink, however; if I press the Overdrive button to over drive off the OD light goes out. Any suggestions.
Thanks for any suggestions, I have not seen any post after advance searching for nearly an hour.
Thread
Thread Starter
Forum
Replies
Last Post