New CATS , X-Fac & Dynomax PIC
#1
New CATS , X-Fac & Dynomax PIC
Picked up car today after redid Full Exhaust from CATS to mufflers. Installed Random Cats, Planet Soarer X Factor 10" X chamber, full Mandrel Bent Section 2 1/2 pipe, and DynoMax Ultra Flow Mufflers. Heres the pic. Will post more close up's of Cats and X Factor chamber, Mufflers later. Unichip Dyno Tune and Zex kit finish on Tue 7-12-05 !
Last edited by jgscott; 07-08-05 at 05:15 PM.
#6
EV ftw!!!
What is the reason why you installed an X chamber rather than an X-pipe?
Please post some dyno results and video clips!
Please post some dyno results and video clips!
#7
Originally Posted by Hameed
What is the reason why you installed an X chamber rather than an X-pipe?
Please post some dyno results and video clips!
Please post some dyno results and video clips!
I reset my ECU, its takes ECU about 200 miles to fully learn and adjust. But I can feel a different in midrange and the car is breathing on top near 6000RPM and pulling harder. My trip computer use to get avg best of 19.6 MPG and it is now reading at 21.8 . I could never get it out better than 19 before.
Last edited by jgscott; 07-09-05 at 04:44 PM.
Trending Topics
#10
Thanks to everyone for the Comps !
Guess what. I am in the process of Dyno tunning a 125 shot Zex kit and Unchip. This system I built is great but I had another idea and I am going to SELL IT less the Mufflers.This a complete 2.5 Mandel bent system. Because of the high flow required by the Nitrous. I am going toduplicate copy this system using bigger 2 3/4 inch piping with a change over for the track. Here is your chance if you have a SC400 to get a great system that will bolt or Weld up perfect already built with the midrange X - Factor mid X chamber. I will be posting the 2 1/2 system you see here in the SC FOR SALE SECTION .
Guess what. I am in the process of Dyno tunning a 125 shot Zex kit and Unchip. This system I built is great but I had another idea and I am going to SELL IT less the Mufflers.This a complete 2.5 Mandel bent system. Because of the high flow required by the Nitrous. I am going toduplicate copy this system using bigger 2 3/4 inch piping with a change over for the track. Here is your chance if you have a SC400 to get a great system that will bolt or Weld up perfect already built with the midrange X - Factor mid X chamber. I will be posting the 2 1/2 system you see here in the SC FOR SALE SECTION .
Last edited by jgscott; 07-11-05 at 04:02 PM.
Thread
Thread Starter
Forum
Replies
Last Post