Got my turbo SC3 running, quick video
#1
Pole Position
Thread Starter
Got my turbo SC3 running, quick video
Just got my car running and put a decent tune on it. The video is not very long, it's just inside/outside shots of hammering in 1st and a little in 2nd gear.
Car is on low boost, just off 1bar spring in the wastegate right now for pumpgas (14.5psi)
VIDEO (1.7mb)
-Hal
Car is on low boost, just off 1bar spring in the wastegate right now for pumpgas (14.5psi)
VIDEO (1.7mb)
-Hal
#4
Pole Position
Thread Starter
Originally Posted by sc300tt
Lol at Oil Light.
Car sounds good. What tranny are you running, it sounds like it was slipping/hit the rev limiter.
Car sounds good. What tranny are you running, it sounds like it was slipping/hit the rev limiter.
I'm using a TH400, and yeah it was on limiter.. it's presently set at 8000, I'm going to up that about 1000 tonight to help keep it off.
It's time for cutting out the wheel wells, bolting on my 28" bfg's, and adding 20 more psi...
#5
Originally Posted by DynoMagic
oil lights are overrated... something about removing the factory ecu and wiring harness made it freak out...
I'm using a TH400, and yeah it was on limiter.. it's presently set at 8000, I'm going to up that about 1000 tonight to help keep it off.
It's time for cutting out the wheel wells, bolting on my 28" bfg's, and adding 20 more psi...
I'm using a TH400, and yeah it was on limiter.. it's presently set at 8000, I'm going to up that about 1000 tonight to help keep it off.
It's time for cutting out the wheel wells, bolting on my 28" bfg's, and adding 20 more psi...
That car should be well into the 9s