SC3coupe

iTrader: (4)

I would like to get the clutch replaced on my SC300. Looking for a detail orientated shop that would be gentle to the interior, put all the bolts back on, put the driveshaft the same way it comes out. 2JZ / Supra experience would be ideal. Would like the flywheel to come off, surfaced.. and change the rear seal as well.

Any recommendations..?

mrkim

depends where your at... I trust MVM here in San Jose or Eurotek at San Carlos

shookatash

iTrader: (1)

Precise Auto Repair and Four B are two places I've taken my cars to. Precise's labor rate I believe is cheaper and they seem to know japanese cars very well. One example - had to replace my water pump on our old 07 is250. dealer wanted $900, precise charged me $475.

They also R&R'd my coilovers, swaybars, and under brace for $375 - took them about 5 hours I think.

warandcar

thumbs up for a good shop!

Funktion

I am going to impact performance today to do some modding. I was wondering anyone have dealt with Kris before?

Nat

iTrader: (1)

i'm going there today around 4PM. I have deal with Kris and Carlin. They are both very knowledgeable guys. My air suspension and numerous other mods were done by Impact Performance.

lbintab

iTrader: (1)

Yup. Good guy

Supraristo

iTrader: (12)

If you have to ask, then dont go

GiantsFan

iTrader: (9)

Went to impact for my coils. Carlin is a cool guy ...

kickin8

iTrader: (1)

+1 for Carlin....

Sffd103

iTrader: (16)

Carlin in Kris are good people and know their stuff.

daniel3ooo

iTrader: (3)

Can anyone confirm that Impact Performance has moved to San Mateo??

RMMGS4

iTrader: (5)

That's confirmed. They just moved in. There should eventually be some type of grand re-opening event at the new location:

71 A East 21st Ave, San Mateo

For now you can expect to see the Impact Vendor Booth attending the Amped Event.

Dark9t316

Hi,

Any good shop recommendations for installing lowering springs in the Fremont surrounding areas?

I checked with Sonic Motorsport but their prices are too high.

I am also considering installing them myself.

Thanks!

Andrew@SonicMS

iTrader: (1)

I just PM'd you.

I believe we can work something out.

- Tom