ClubLexus - Lexus Forum Discussion - Conversation Between thomas1 and code58

Conversation Between thomas1 and code58
Showing Visitor Messages 1 to 2 of 2
  1. code58
    01-23-11 12:52 AM
    Greetings Thomas,
    I have one of the Harbor Freight arbor presses and confess that I haven't had to use it yet. I have the parts made for a 20 ton press and am a little reluctant to finish it because I don't have room for it. (that's what happens when you're a tool and equipment freak.) I'm not sure the arbor press would do it. Could always try and if it didn't work, then take it and have King Kong do the job. Shouldn't have to do any heating if there is enough power.
    Let me know when you're down for the new grand child. I'll come say Hi and buy you coffee or lunch. Roger
  2. thomas1
    01-22-11 06:24 AM
    Good morning Roger, I just changed the control arms on my RX, but did note a little bearing scrapping on the front left bearing on the hub...My question is do you think I can change that bearing (press it out) with one of the arbor presses at Harbor Freight Tools, or am I playing with fire? My buddy has a Harbor 3 ton arbor press, but do you have to heat up or cool anything to get them out safetly.? Tom
    By the way my daughter lives in Chino Hills closer to you and is expecting my 9nth grandbaby....So I will probably be down there in June... Anyway tell me what you think about doing it myself or taking it to NAPA and having them press it out...

All times are GMT -7. The time now is 04:00 AM.

Copyright © 2000-2017 Internet Brands, Inc. All Rights Reserved