VHC how to operate on 04 LX470
#1
Pole Position
Thread Starter
VHC how to operate on 04 LX470
Hi Guys this might be a stupid questions. But how do you operate this ride height control. I try adjusting it on high when car in park but nothing happen I also try low as well, is it suppose to raise the car when in park or only when it's driving? The Manuela is not very informative as well. Thanks in advance guys.
#2
Pole Position
Thread Starter
Hi Guys this might be a stupid questions. But how do you operate this ride height control. I try adjusting it on high when car in park but nothing happen I also try low as well, is it suppose to raise the car when in park or only when it's driving? The Manuela is not very informative as well. Thanks in advance guys.
#3
Pole Position
Steve
#4
Pole Position
Thread Starter
I'd start by checking fluid level in the AHC reservoir. From there, with engine running, e-brake on and truck in "park", it should go up or down, depending on which end of the button you push. I'd also make sure the doors are all shut. Report back with what happens (or doesn't happen).
Steve
Steve
#5
Pole Position
Thread Starter
I just want to update this, thanks to Steve for replying. It works!!! The car needs to be park, parking break on and doors close. Surprise I did not see this instruction in the Manuel. Thank you
Thread
Thread Starter
Forum
Replies
Last Post
Burst32
IS - 2nd Gen (2006-2013)
15
03-20-07 09:55 PM