When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Thanks, What did you decide on covering the one you built?
I'm going to start with Herculiner paint on truck bed liner, use metal edging on the top front and sides for protection and to straighten up the edges a bit, then most likely carpet or rubber line the inside of the drawers, and then I have a few ideas for the drawer front but I'm not locked down on that yet. I was going work on it today after work but I forgot to bring the Herculiner with me.
I have made significant progress on my storage drawer build this week. I got the driver side wheel well covers completed. Two section are removable. Giving me access to my compressor and additional storage. I have a 360 degree swivel Air compressor outlet and the control for the 3000 watt inverter built into it.
Looking better and better. I have a few more parts that came in for my drawer build and I'll post up info once complete.
Our builds are going along similar paths and timelines.
If only we lived close to each other.
There would be a garage night every night
Looking better and better. I have a few more parts that came in for my drawer build and I'll post up info once complete.
Our builds are going along similar paths and timelines.
If only we lived close to each other.
There would be a garage night every night
So I have actually completely finished my storage and drawer build. Today I completed the wheel wells. Added a lock to the drawer, and installed recessed anchor tie downs. Theses also serve as pulls for the top slides.
03-08-18, 05:54 AM
