Hi everyone before two months i took my car to "alodaib" its a huge workship for lexus and toyota in saudi arabia

After i changed all four air suspensions shoks , brakes pads ,axle boots , arms and tie rods

Because of accident and cross the sidewalk so after the accident and before change or replace anything car was okay with no leaning only noising sounds so after replacing the parts car leand on the front right and goes up from the rear left!!!

I put it in the workship for 2 weeks everytime they fix it it go down again after 15-30 minutes no one know where the problem comes from they told me everything is good and new

What make them chook is thet after they replace the arms the car lean on front left and raise from rear right

The replaced the arms again and the car lean ro front right and raise from rear left

And i went to the dealership but they refused to accept my car because its US lexus they only accept SA saudi arabia lexus cars i dont know why!! But i dont have time to fight with them and etc...

My car is now over 200k miles over
So please help

I took car of it always

I hope someone know this and already had it

 

Sorry to hear about your problems and your frustrations but sounds like Alodaib isn't concerned about fixing your problems but more concern about taking your money. Its apparent your air suspension isn't fixed. You could have severe frame damage after the accident but they should be able to see that. Good Luck because you might have to fight with them to solve your problems.

 

I wonder if one of the factory height sensors was mounted wrong, or that after having the new air shocks put in they have to be synced.

 

well the saudi dealership will never accept to fix my car because its US

so thats mean i have to go to UAE and visit they dealership


well alodaib is much famuos then the dealership with car fixing!!

 

well they checked it out and its okay

also they tried manuly height the car sensors and they did it but still lean down again

thats make them crazy too, because they dont know the problem they said im the first one showed up with this problem!!!


"sorry for my bad english"

 

This makes me think that maybe they didn't pre load the suspension when installing the new parts. Pre loading the suspension is when you install the suspension but don't torque the bolts down until the suspension is under load. Any pictures of the "lean" or measurements of the height of each fender?

 

thats seems good thank you for your help


and i will take a picture and load it in the topic


thank you bro