PRSUIT460

iTrader: (3)

Looks great! Looking forward to changing out those lights on my 460!

Hoovey689

iTrader: (16)

Very unique. I like it!!

jbrittmart

V-LEDS has them in a bunch of colors.

they're the best LED company i've used... the brightest i've seen.

http://www.v-leds.com/194-168-158-LED/c506139-1-2/

i'm gonna do this.

jbrittmart

oh and i found these instructions to get to the bulb in another thread.

looks like you don't have to pull the bumper.

Originally Posted by Shibumi1 View Post
i did it without removing the whole bumper.. remove the grill (1) 10mm socket. the remove the plastic clips holding grille on each corner.then its easy as pulling the grille forward gently as u release the locking tabs (4).. once the grille is out you'll see a plastic trim w foam tucked behind the bumper trim on either side of the grille opening.bend it down then you'll see 2 wiring harnesses unclip them or bend the metal tabs holding them in place an you'll see the bulb socket reach in an turn it counterclockwise an pop the socket out.

PRSUIT460

iTrader: (3)

I ended up ordering http://www.v-leds.com/Interior-LED/G...04828-1-2.html

I8ABMR

your car sounds pretty hooked up from the signature. Can you post some normal pics of your ride??

adamls2

how much would this cost for the dealer to install each or both of them??

Tee

I have some LED 194's, I'm trying this mod this weekend.

blackz405

Please take some pictures for us. One of my corner bulbs needs to be replaced. Thanks.

Tee

When you say corner bulb are you refering to the side marker light?

If so that is easy to replace.

Turn your wheel inward, remove the fender lining, then reach up and turn the bulb socket to replace the bulb.

blackz405

---------------------------------------------
I need to replace the clearance (nike shape) light.

cmasten

Curious if your guessing here or you saw them drop the bumper , I just used Shibumi1's great write up to do this myself in about 20 min and from what I can tell, dropping the bumper would not even give you access to the area that the bulb resides in. Its on the top outside of the headlight assembly, from what I saw the dealer would access this the same way I did which is through the grille and the pull down plastic panels etc all look like they were made for access this way. It should be a 1/2 hour tops for a dealership to replace the bulbs on both sides. Taking the top engine covers off was more than half the time it took to do this.

Maybe they did it that way, but were doing other work for you that required dropping the bumper

JSTALEX

Cost and link where we can buy these???

Ricks619

Looks great, I was looking into doing mines too. I was told you could use 921 bulb as well which is super bright which won't break the bank, but still little concerned on the power. It draws a higher current 1.4A at ltitle over 17watt compare to approximately 0.4A on the stock bulb.