Crybicki

Hey CL! So here is my ordeal: I have two LS400's. One is a black 92 (my daily driver), the other is a white 93 ( my parts car). So I have been taking parts off the parts car and I have taken apart most of the electrical already, so no power to it. I however didn't think to raise the power seats up so I could take them out before hand. Is there a way to use a battery to plug directly into the seat switch on the power seat to get it to move? I need to do both driver and passenger. I so need to move the headrests up so I can take those out. So you electrical gurus, I would appreciate the help. Thankyou!

EDIT: I was able to get the rear bolts out of both seats. Now I just have to find out how to get the front ones out as they are all covered due to the position of the seats.

timmy0tool

iTrader: (7)

can't just plug in a battery in the orginal spot? did you take out the main harness already?

you will have to find the module that powers the seats and supply 12Vs to it.

Crybicki

No, can't plug battery in, most electrical stuff already out. I know I need to power the seats up but I don't know how to do that, hence my post.

Largefarva

Feed power to the blue/white and ground to the white/black.

Crybicki

Thank you! That's exactly what I needed to know!

Crybicki

I'm not surprised this worked but I am absolutely ecstatic right now that it did! Thankyou, thankyou, thankyou! If I could buy you a beer right now, I would!