jasonm

iTrader: (5)

Got new fenders and compressed flat the inner lip instead of the roller and had some body work to do a very light pull/flare and kept the original lines on the edge...then painted fenders, hood, front and rear bumpers and trunk lid and door handles, basically anything that was faded from the sun.

Need to go 215's on the front and go lower in the near future.

Vincent123

iTrader: (24)

lookin proper

whit3b0y

looks clean, But I do agree. It does need more low.

Schnitz

iTrader: (5)

Looks great! If I could find fenders for my generation I'd do the same.

PureDrifter

iTrader: (10)

yay no more wrinkled/ruined fenders!

MyC4LS

this car is one of my inspirations for my build. I got 18x9 +45 and 18x10 +20 with 15mm spacer. I was just looking in to doing my fender work a little too. Looks good bro. Dis u add any suspension kits or just fender work and megans?

PureDrifter

iTrader: (10)

hope you aren't trying to go as aggressive as jason

MyC4LS

Maybe. Especially since im researching on how i can get a lil lower with mine and slight more camber. Im not driving it as much now because i got my cressida but we will see.

PureDrifter

iTrader: (10)

lol i meant because unless you get ridiculously thick spacers you're not even close.

MyC4LS

lol nah im selling my works soon. After they get fixed so that i can get my wife some wheels and finally some aggressive wheels for mine. Only can do so much when ya married with three kids feel me

RA40

iTrader: (6)

Looking good Jason

jasonm

iTrader: (5)

Im on megans and cut the hole for the UCA..Going lower is actually a challenge as the rim is poking...so I will get some 215/35's and try a little at a time...can afford to jack up these fenders with the lips slamming on the edge of the fender..I may need to pull a little to tuck rim, without messing up the work that was just done or get new rims with not as agressive offset...who wants to do that. Thanks PD.

jasonm

iTrader: (5)

thanks Vincent and Schnitz..admire both your cars

bboynoodle

great lookin car! Where did you pick up the fenders from?

jasonm

iTrader: (5)

they are stock...from a member here. My other ones had the inner metal cut out and weakened it too much and I bent them so been waiting and saving to do this and paint other parts at the same time.