1993 LS400 Passanger side window motor problem
#1
Driver School Candidate
Thread Starter
Join Date: Jan 2010
Location: AZ
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
1993 LS400 Passanger side window motor problem
Replaced the passanger side motor with a brand new one, and boltd it all up.
However, the window "sticks" and sometimes will not move up or down -- this is from the passanger side switch.
From the Driver's side switch it wont or hardly function at all.
The drivers side window switch for the driver's window works just fine.
Any ideas on what to do to get the passenger side working properly?
However, the window "sticks" and sometimes will not move up or down -- this is from the passanger side switch.
From the Driver's side switch it wont or hardly function at all.
The drivers side window switch for the driver's window works just fine.
Any ideas on what to do to get the passenger side working properly?
#3
Driver School Candidate
Thread Starter
Join Date: Jan 2010
Location: AZ
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
Connections?
Its all "plug and play" plugs right?
Or are you saying perhaps the pins them selves that go to the switch?
I think if were to a apply 12 volts to the window motor directly it would move with alot of force.
Does the window motor see a full 12 volts or some fraction of that?
Or are you saying perhaps the pins them selves that go to the switch?
I think if were to a apply 12 volts to the window motor directly it would move with alot of force.
Does the window motor see a full 12 volts or some fraction of that?
Thread
Thread Starter
Forum
Replies
Last Post