polobai

Check out the thread on VIPstylecars for the full writeup:

http://www.vipstylecars.com/forums/s...ad.php?t=17331

Here is a teaser...

LiCelsior

iTrader: (32)

very nicee.

PureDrifter

iTrader: (10)

nice and clean, need a side profile shot for fitment!

bukbuk

did you have to do any fender rolling/ shaping, did you remove any plastics?

skperformance

iTrader: (6)

Never been the biggest fans of UAS, but your car looks clean.
Nice to see you got it right, right out the gate.
Keep it up.

Zero_One

iTrader: (1)

Looks great! Clean LS nice install.

polobai

Thanks for the comments-I didnt have to remove any plastics (fender lining)-i had to cut a lower part on the drivers side fender liner as it was in the way of the solenoid. No fender rolling either-but the wheels dont sit flush-they tuck in. I may get spacers and push them out-but not sure on that as of yet. Here is a rear profile shot:

steveski

Sweet looking LS - nicely done

ClutchOne

Looks Good but Yea you need Spacers

Were is you Exhaust ???

Li Ls4

iTrader: (12)

came out ready good man,

i like how the tail lights came out also, never seen it done b4, looks good

polobai

Thanks-I did the muffler delete on the exhaust-but i got something else up my sleeve for that (comming soon). Thanks for the tails-i didnt like the red/clear look so much, so I had the red/clears smoked to acheive the look.

el maestro

iTrader: (3)

your a floridian too....I went coils on my 96 LS first but hopefully sometime soon i want to slip some bags over them.


Looks good man....we need to get some Vip meets going in the Tampa area.

polobai

Here it is aired up:

polobai

And dumped-I think I'm going to go with 25mm spacers to push it out a bit. I still want the wheels to tuck, but want them out further as well

polobai

Here is what I have planned for the exhaust-Trust SP for a z32 300zx...it will be different than the rest and should go well with the lip kit.