thebeeguy

So I deleted my EGR (No i didnt buy the lextreme kit). But I followed directions I found on this site. My question is, which plug do I put the resistor in? There are 2 plugs that go to the EGR, one toward the front of the engine (right next to the Diagnostics port), and 1 toward the back attached to the VSV.

Also, the resistor is supposed to be a 10k Ohm 1/2 watt resistor correct?

I put a resistor in the plug that was attached to the VSV, and the check engine light for the EGR came on a day later.

I then put resistors in both plugs and the same thing, a day later the EGR code comes back up.

Am I using the wrong resistor or something?

thebeeguy

Nevermind I'm an idiot. It goes in the plug that is directly under the intake manifold where the EGR bolts to the manifold. I didnt even notice it when I deleted the EGR