Cel codes after maintaince
08-01-06, 06:49 PM
#1
Driver School Candidate
Thread Starter
Join Date: Aug 2006
Location: OR
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Cel codes after maintaince
Hey, I have been lurking around this forum for a while and just registered.
I had completed a major repair on my 91 ls400 about a month ago. The repair included a timing belt change, water pump change, fuel filter, replacing the rotors and caps along with cleaning the throttle body. All this I did myself with the guide from Lexls.com.
The CEL lights up rarely. I have reset the ECU to capture the codes that apply to the problem. I have noticed the light only goes on when the car is slow (stop/go traffic, sitting at a light, starting the car) and most often when the engine temp is in the cool range but sometimes when it's normal. I have driven the car for a month and I get the following codes.
13, 25, 26
What could be the cause of this problem? Usually once the car is traveling 40mph or more, the light goes away.
I had completed a major repair on my 91 ls400 about a month ago. The repair included a timing belt change, water pump change, fuel filter, replacing the rotors and caps along with cleaning the throttle body. All this I did myself with the guide from Lexls.com.
The CEL lights up rarely. I have reset the ECU to capture the codes that apply to the problem. I have noticed the light only goes on when the car is slow (stop/go traffic, sitting at a light, starting the car) and most often when the engine temp is in the cool range but sometimes when it's normal. I have driven the car for a month and I get the following codes.
13, 25, 26
What could be the cause of this problem? Usually once the car is traveling 40mph or more, the light goes away.
Thread
Thread Starter
Forum
Replies
Last Post
jamesJoann
LS - 1st and 2nd Gen (1990-2000)
2
09-01-15 02:30 AM