1990 Ls400 Child Restraint Seat Top Strap Bracket Installation Diagram
hi there,
Im looking for a diagram for the CHILD RESTRAINT SEAT TOP STRAP BRACKET INSTALLATION for 1990 LS400 (Celsior C Type - F Package). I imported this car from Japan but unfortunately didnt come with owners manual. Apparently, the diagram is located on pg 61 of the manual. I have taken pics of the parcel shelf where i think the anchor point should go. I just need to make sure I'm right. |
1 Attachment(s)
here's the shot of the left side
|
1 Attachment(s)
here's the center...
|
1 Attachment(s)
and here's the right side...
|
I have two kids and understand your needs. The US Spec owner's manual does state the three tethers. Lexus sell a kit for that. I dont remember if the kit comes with three hooks or one hook.
I can take some pics if u r interested. |
Originally Posted by Lextreme
I have two kids and understand your needs. The US Spec owner's manual does state the three tethers. Lexus sell a kit for that. I dont remember if the kit comes with three hooks or one hook.
I can take some pics if u r interested. |
1 Attachment(s)
Here are some pic. I installed two kits. I removed the middle one because the baby seat were sliding everywhere.
|
1 Attachment(s)
Here is another hook attach to a infant seat.
|
1 Attachment(s)
Here is the middle one. Removed......
|
1 Attachment(s)
A closer look at the hook.
|
thanks heeps for the pics! its been a big help...i finally done it!
|
FYI,
I hope u didnt remove the carpet to install the hooks. |
I just had to cut 3x25mm holes on the parcel shelf for the anchor point kits. Unfortunately mine wasnt pre-welded i had to put custom made plates as anchor point. Here in australia we have to install this anchor points and an unleaded fuel restrictor in order to register an imported car. Thanks very much for your help.
|
That is too bad. The US Version is pre-drilled.
|
Celsior mods for Australian compliance
Originally Posted by loveMyLs
I just had to cut 3x25mm holes on the parcel shelf for the anchor point kits. Unfortunately mine wasnt pre-welded i had to put custom made plates as anchor point. Here in australia we have to install this anchor points and an unleaded fuel restrictor in order to register an imported car. Thanks very much for your help.
Good to see a fellow Aussie CL member. I'm about to purchase a type C Celsior :) without the leather and was wondering what mods you have done for compliance and how much $? I am an enthusiast and let me know if I can be of any help. Cheers psls400 |
All times are GMT -7. The time now is 02:28 PM. |
© 2024 MH Sub I, LLC dba Internet Brands