hello to everyone that is reading this post.

this is my first time posting in here. just have a few question to ask for a pioneer avhp3100 HU. here goes. im using a toggle for the video bypass. i been searching all around for a diagram of a lot of a toggle switch seen alot but people never did one only for a relay. i guess and some people explain it but sometimes will confuse a person. below is the things i did to my toggle and my question is did i do it right or not?

1. brought a 2pin toggle switch at radioshack. ( 2 little pin at the bottom)
2. pin one is wire to ground
3. pin two is wire to the green ebrake wire from HU

and that is it can someone help me and tell me if i did it right?