HID lights IS300
There are Its a tricky deal. I have found removing the front bumper is the easiest way.
Remove bolts from the bumper to fender.
Remove the bolts from the lower plastic panel.
Remove 3 bolts from the grill to the front bumper.
The tricky part is behind the inner fender well there are 2 nuts that hold the headlights in. They are 10mm nuts.
Then remove the 2 bolts that hold the headlight to the radiator support. They are the easiest they sit right on top.
Finally pull the headlight out. It will be a little hard so you will have to put a little elbow grease behind it. There are small black plastic pieces that are connected to a small bar on the bottom of the headlight. They are also clipped into the headlight base so once you start to pull it will come out.
On my car once i pulled the headlight out a little because of how tight the headlight is i would have to remove each bulb out of its sockets because the wiring harness doesnt have much room for movement.
Remove bolts from the bumper to fender.
Remove the bolts from the lower plastic panel.
Remove 3 bolts from the grill to the front bumper.
The tricky part is behind the inner fender well there are 2 nuts that hold the headlights in. They are 10mm nuts.
Then remove the 2 bolts that hold the headlight to the radiator support. They are the easiest they sit right on top.
Finally pull the headlight out. It will be a little hard so you will have to put a little elbow grease behind it. There are small black plastic pieces that are connected to a small bar on the bottom of the headlight. They are also clipped into the headlight base so once you start to pull it will come out.
On my car once i pulled the headlight out a little because of how tight the headlight is i would have to remove each bulb out of its sockets because the wiring harness doesnt have much room for movement.
Thread
Thread Starter
Forum
Replies
Last Post
zzublexus
ES - 1st to 6th Gen (1990-2018)
26
Jan 21, 2019 08:34 AM




