SmartTap Relay Installed
Apparently, I did not install it properly at first. 
04-01-17, 11:25 AM
#63
Ya know, it's funny how important the tap and flash feature really is. I have 3 flashes on my truck, non adjustable, and I really missed not having it on my F. There was a post in the GSF forums about 5 weeks ago describing the feature on the GS F and how to adjust the no. of flashes. I was envious, then 4 weeks later this thread show up. Now, I have it, and it sure makes life easier. However, I'm still amazed at the number of boneheads who somehow don't seem to know what a turn signal is.
I'm old enough to remember when cars didn't have turn signals. They became standard equipment in 1956.
Lou
I'm old enough to remember when cars didn't have turn signals. They became standard equipment in 1956.
Lou
The following users liked this post:
JPxMODz (04-01-17)
04-05-17, 11:49 AM
#64
Recieved my replacement SmartTap. Everything including ALL features are functioning correctly. I'll report back in a few days if things are good to go.
The unlock 20-sec arrival works fine. It won't work using keyfob. You have to push the unlock button on outer door handle for it to work. Just the lock 20-sec delay works fine from the keyfob
The unlock 20-sec arrival works fine. It won't work using keyfob. You have to push the unlock button on outer door handle for it to work. Just the lock 20-sec delay works fine from the keyfob
What year is your vehicle? I have a 2012 and don't have am unlock button on my door handle. I only have the lock button. When you grab the handle, that is when it unlocks. I bought the smart tap and all works well too except the arrival.
The following users liked this post:
JPxMODz (04-05-17)
04-05-17, 12:33 PM
#67
I called diode dynamic regarding the arrival situation and they said they have been made aware of the situation and are trying to work on a solution. Once the issue is rectified, they will contact their buyers and replace it. They need some assistance as they are looking for test vehicles so if anyone is in the area, feel free to give them a call. Maybe you can negotiate something with them hahaha
(314) 205-3033 that's their number
04-05-17, 12:43 PM
#68
I called diode dynamic regarding the arrival situation and they said they have been made aware of the situation and are trying to work on a solution. Once the issue is rectified, they will contact their buyers and replace it. They need some assistance as they are looking for test vehicles so if anyone is in the area, feel free to give them a call. Maybe you can negotiate something with them hahaha
(314) 205-3033 that's their number
(314) 205-3033 that's their number
To bad, I wish the opposite were true. The unlock feature to me seems more desirable than the lock feature. I'll setup a ticket with support at DD also. Hopefully they will rectify this issue
Thanks for pointing this out
Last edited by JPxMODz; 04-05-17 at 12:50 PM.
04-05-17, 12:55 PM
#69
I just installed the SmartTap in my 2014 IS F this evening. Installation went fine. You do need to contort yourself upside down and really crawl under the dashboard to get the job done. I also pulled the lower dashboard cover (2 screws) for better access, and used a really good flashlight.
All functions work so far except the unlock lights on for 20-sec (arrival) delay. The lock function w/20-sec (departure) delay works, one touch 4-blink works, and the variety of hazard light patterns work. I was mostly after the one touch 4-blink feature. First day only, will post/comment if something goes south.
Do make sure you pull the right relay. On my 2014 the OEM relay was light tan (P/N 81980-30170). There was a similar looking relay further up the dashboard that was green. That one is evidently for your stop lights... don't pull that one (it is also keyed differently). Lou's post (#43) on the prior page with the link does show the correct relay location and mounting point, just don't assume your OEM relay is the same color.
Regards,
- Kirk
All functions work so far except the unlock lights on for 20-sec (arrival) delay. The lock function w/20-sec (departure) delay works, one touch 4-blink works, and the variety of hazard light patterns work. I was mostly after the one touch 4-blink feature. First day only, will post/comment if something goes south.
Do make sure you pull the right relay. On my 2014 the OEM relay was light tan (P/N 81980-30170). There was a similar looking relay further up the dashboard that was green. That one is evidently for your stop lights... don't pull that one (it is also keyed differently). Lou's post (#43) on the prior page with the link does show the correct relay location and mounting point, just don't assume your OEM relay is the same color.
Regards,
- Kirk
The following 3 users liked this post by JohnMorgan:
04-24-17, 08:11 AM
#72
Former Sponsor
The following users liked this post:
Vervish (04-24-17)
04-24-17, 09:10 AM
#75
Nice video!
-Josh
-Josh
__________________
Your #1 Dealer for Aftermarket Performance Products
Orange County, CA
Email: info@merakiautoworks.com
Text/Call: 213 394 2886
Website: www.MerakiAutoworks.com
Your #1 Dealer for Aftermarket Performance Products
Orange County, CA
Email: info@merakiautoworks.com
Text/Call: 213 394 2886
Website: www.MerakiAutoworks.com
